The 3D screen is projected on many different layers of water

 The 3D screen is projected on many different layers of water. The water surface that reflects the image to our eyes is due to the interface between water and air. And water also allows light to pass through. air spaced.or change water with plastic, and then use a projector to drain each water surface of each layer of water.One projector at the correct height of that floor is drained in each layer.Do not stack the projector in the top layer of water. for each water layer is a 3d cross section of the 3d block. the image reflected from the water surface of the lower layer penetrates the upper water layers to our eyes. The light is dimmed, so we have to light more strongly. The lower layer the more brighter. A projector that cannot drain a layer of water uses more projectors around.

Comments

Post a Comment

Popular posts from this blog

The 3d projector shines on the air with the converging invisible light that heats the steam to white

  The 3d projector shines on the air with the converging invisible light that heats the steam to white.Obviously transparent steam is transparent, but at 100 degrees C it is white. and then using the invisible light to converge each spot heats the steam to a higher temperature to make it white, then project the image from the projector. white reflects all the colors like a white screen. Color far close out 3d model
Read more

The 3d screen shines on the air with a laser beam of invisible light as small as electrons

  The 3d screen shines on the air with a laser beam of invisible light as small as electrons. I create small lasers with electrons parallel to each other. So let the laser shoot the scattered electrons to create sparks into light. if the laser beam is big, it repels the gas molecule. the invisible light laser does not create trails. then use a color filter to create color. The spark generator is attached to the glass so that it doesn't deviate color. Create colored dots far closer to the 3d model
Read more

Store electricity by demagnetizing electrons so that it can be easily stored in the flask without running out into lightning, damaging the battery

  Store electricity by demagnetizing electrons so that it can be easily stored in the flask without running out into lightning, damaging the battery. The electrons are demagnetized for it and the energy is weak so that when compressed into the tank does not create lightning, it will damage the storage vessel. when the electricity is connected to the ground, the electrons run out into an electric current. Moderate demagnetization so as not to create weak electricity, or when the magnet is recharged, it compresses electrons without the need for large nuclei to occupy a lot of area. store electricity millions of times
Read more